How To Remove Mower Blades Victa

You need to heat the hub and strike it with a hammer in the same direction as removing the blade nut. Remove the engine from the lawn mower click here for a tutorial.

My 1955 Victa Rotomo Riding Lawnmower Mower Lawn Mowers

Stop the engine whenever you leave the mower even for a moment.

How to remove mower blades victa. Remove the blade carrier with blades attached by undoing the bolt in its center which holds it. Start the engine carefully with feet well clear of blades. Consider placing a wooden block under the blade to prevent it from moving around.

Ensure that the mower is drained or low on fuel and lawn mower oil to avoid spills. To avoid internal oil spillage in 4-stroke mowers ensure the spark plug faces upwards to avoid dousing it in fuel. To remove the blade you must turn the blades retaining bolt to the left or counterclockwise.

They are hard to remove and you will undoubtably damage it during removal but. Mow only in good daylight. Place the boss over the anvil and hit it with a hammer rotating the blade boss as you do so this should loosen it and allow it to be removed.

This insures oil does not flow into the intake or exhaust and cause trouble later. The blades need removing from the blade carrier before sharpening. Do not tilt the mower when starting the engine.

Step 2 Remove the carburetor by disconnected any hoses as well as the ignition wires then twist it off the engine. Lawn mower blades are sharp so youll want to keep your hands protected. Either remove the main securing bolt and remove bolts securing blades or remove blade bolts while still attached to the mower.

Either disconnect the fuel line and remove the top cover or empty fuel from the mower before turning it onto. Use a socket wrench turning left for a standard bolt and right for a reverse-threaded one. Either reach behind the blade carrierof the mower and undo the blades requires socket wrench and allen key or if this is not easily accomplished you can remove the entire blade carrier from the mower by loosening the main bolt holding it in place with a socket wrench.

This video is also associated with the followingOil change on mowerhttpsyoutubePyp965w7mmIVicta mower. You may need to tip your mower to remove or replace blades which can be done during a lawn mower service. When looking at the blade boss you will notice on one side there is a hole fill this with WD-40.

This Video Demonstrates how to easily remove a Victa Blade Boss Click Below For More Information Visit our site for more tutorials Parts and lawn mowers for. Ensure that the mower is drained or low on fuel and lawn mower oil to avoid spills. To avoid internal oil spillage in 4-stroke mowers ensure the spark plug faces upwards to avoid dousing it in fuel.

This Tutorial Demonstrates the process of replacing the blades on a victa lawn mower should be similar between models and brands Click Below For More Infoma. Keep hands and feet away from rotating parts beneath mower when engine is running. Remove Spark Plug lead for safety reasons.

Before undoing the blade tip the mower on. Loosen the retaining bolt on the blade. Removing the blade holderhttpsyoutubedRid.

Lift up the mower with the front wheels facing skyward. Remove the muffler from the front of the engine by using a screwdriver to disconnect the 2 clips top and bottom holding it in place. Learn how to remove a Victa engine from the main chassis of the lawn mower.

You may need to tip your mower to remove or replace blades which can be done during a lawn mower service.

Battery Powered Mowers And Lawn Equipment Victa