Remove Fence Post Hydraulic Jack

I found it is best to dig a wide hole around the post using a full sized steel shovel then to switch to a gardening-sized short-handled shovel to clear out the area directly beside the cement. If it doesnt come out easily put some bricks under the jack and lift it higher.

Homemade Toe Jack Constructed From 1 4 Steel Plate And Powered By A 25 Ton Hydraulic Ram Welding Table Welding Projects Homemade Tools

Its hydraulic and highly portable the tool splits in two allowing removal if required and can also remove posts from near walls.

Remove fence post hydraulic jack. In some of the pictures you can see I needed 4 bricks to successfully get a much deeper gatepost out of the ground. Step 1 Dig around the post until six inches of the concrete footing is exposed. The innovative design allows you to apply a tremendous amount of lifting force directly on the post lifting it straight.

A tough tool for a tough job POSTDOZER provides 10 ton of lift to remove fence posts stumps and met posts. Clamp it on and jack it out its that effective. Often youll find the wider the hole you make the easier the rest of the process will be even the digging will be easier.

Start out by digging a whole about two to three feet in diameter around the post. The trick to removing a fence post is to apply force upward so that youre not fighting the strength of the earth on either side of the buried post. Over 50 styles in stock.

Secure the chain with a nut and bolt at each end. Now dig a shallow hole around the post. Once clamps are off remove the tension bar by weaving it out of the chain link.

Wrap a chain around the post and use a high lift jack to pull the post out. Dig a trench next to the footing and tip the post out. Product description The Hi-Lift Jack PP-300 Post Popper is designed to remove metal T-posts wooden fence posts cement plugs or small stumps.

The first step is to remove the fence sections from the post so that you now have just the free-standing post. Fence post removal with floor jack. Mar 22 2016 - Beautiful durable locking shower soap dispensers for hotels ships spas clubs.

Heres a pretty simply method for removing a fence post seated in concreteall without digging or messing with complicated equipment. Dig a 10 inch diameter hole and set the post 13 of its length into the ground set an 8ft post at least 2 feet deep. Start at the end of the fence or a corner post and remove the clamps holding the tension bar in place by removing the nuts and bolts and sliding the clamps up and off the post.

This hole must be deep enough to be able to see the top portion of the cement base of the post. Screw lag bolts through a chain into the broken off fence post and then use a vehicle winchcome alonghigh lift jack to pull the post out. I left the gate on the post as it weighed nothing with the jacks help and it provided an anchor for the fence wire loop.

The easy way to extract-FENCE POSTS.

Post Puller In Action Garage Tools Homemade Tools Welding Projects